CA3-USBCB-01 Data transmission USB cable (2 m)

LT fasteners installed on the control panel (4 / set)The main controller is connected to the man-machine interface for MPI communicationWhen the man-machine interface is installed to the fixed panel for providing dust proof and moisture proof function (1 pieces).When the man-machine interface is installed to the fixed panel to provide dust proof and moisture proof function CA3-USBCB-01. (1)Standard cable for connecting GP3000H adapter and GP3000H CA3-USBCB-01
Length: 3 meters. Used to install the GP3000H series to a commercially available support arm or panel.512MB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card.15 inches, GP installed to the hard panel to provide dust and moisture proof function CA3-USBCB-01. With the installation of screws (4 / sets), for the GP4000 series back mounted to the fixed panel models. (2 / set)5.7 inches thin film used for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set).10.4 inches (TFT), for the protection of the man-machine interface from oil and chemical pollution (5 / set) CA3-USBCB-01. Used in a variety of host and man-machine interface for RS-232C connectionConnector for connecting DC power cord (5 / set).Standard cable for connecting GP3000H adapter and GP3000H.
Length: 10 meters. Touch screen anti ultraviolet protective film (1 pieces).Engineering documents created by the LT interface to download images and logic programming software through the USB interface.LT4000M (module type DIO), PNP output, DC24V (host).Portable GP2000H series models accessories, RS-232 cable with D-Sub connector (3 meters).Adapter for EX module (5 / set))Cable for connecting GP3000 to various modulesFor the direct connection of the MITSUBISHI FX series CPU PLC (not to be used at the same time, the programmer) length: 1 meters CA3-USBCB-01. Expansion module for the GP3000 access to the CANopen networrk and communication with the CANopen master stationThe man-machine interface directly connected MITSUBISHI electric PLC FX series CPU programming port CA3-USBCB-01.