GP3000H-CBLHD-10M GP3000H belt joint hard straight cable (10 m)

The man-machine interface directly connected MITSUBISHI electric PLC Q series CPU programming port.When the man-machine interface is installed to the fixed panel to provide dust proof and moisture proof function. (1)Mounting screws (4 sets) to be fitted to the hard panel at the interface of the machine GP3000H-CBLHD-10M. OMRON SYSMAC series PLC or other main controller) connected to GP, length: 5 m GP3000H-CBLHD-10MAdapter for EX module (5 / set)10.4 inches (STN), the replacement of the host backlight (2 / set).Used for surface protection of man-machine interface from oil and chemical pollution (5 / set).For the DVI input to GP3000Used in a variety of host and man-machine interface for RS-232C connectionInput / output hybrid I/O modules, including 32 point NPN/PNP input and 32 point NPN transistor output5 / sets5 GP3000H-CBLHD-10M. 7 inches thin film used for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set)COM1 interface with the cable (RS-232C), used to connect directly to the CPU series PLC FX (not the same time using the programming controller)USB cable to prevent disconnection of the fastening clip (5 / set)The main controller is connected to the man-machine interface for MPI communicationDisposable film (5 sheets / sets) for protecting screen against contamination of human computer interfaceExtension cable for connecting USB (Type-A) interface to front panel GP3000H-CBLHD-10M. The three color tower lamp installed on the fixed panel is connected with the human machine interface through the USB interface.USB cable fastening clip (Type-A) for preventing disconnection of connection (5 / set).13 pin input connectors for HTB and 16 pin output connectors. (1 / set)Protection for GP rear connectors (large and small for each of the 1).Touch screen anti ulttraviolet protective film (1 pieces) GP3000H-CBLHD-10M. To prevent the connection of disconnected USB cable fastening clips (Mini-B USB, 1 interface, 5 / set)Cable for connecting GP3000 to various modulesFor connecting the GP3000H cable connector andd the external output port, the output of the following connectors: serial: D-Sub 9 pin (convex), Ethernet: Jack RJ-45 (Modular), other: terminal block GP3000H-CBLHD-10M.