CA3-USBCB-01 User's Manual ()

Transmission screen data, such as the USB cable, PC (Type-A USB) to the man-machine interface USB (Type-A)GP-230/250/270 series is replaced by ST series, the gap filled with the opening of the panelUse external output for the GP3000 series of auxiliary connectors (5 / sets).For RGB input USB cable to prevent disconnection (2 / set)13 pin input connectors for HTB and 16 pin output connectors CA3-USBCB-01 User's Manual CA3-USBCB-01 (1 / set)10.4 inch TFT models applicable parts, for the 10.4 inch man machine interface (TFT) into the 10.4 inch GP2500 (TFT) in the installation of the required accessories.COM1 interface with the cable for direct connection to the CPU series PLC AEngineering documents created by the LT interface to download images and logic programming software through the USB interface CA3-USBCB-01 User's Manual. Suitable for A/B+ Type modelsThe main controller is connected to the man-machine interface for MPI communication5.7 inches thin film used for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set).Suitable for GLC2300 seriesCOM2 adapter for converting the COM2 interface to the RS-422 terminal block7 CA3-USBCB-01 User's Manual. 5 inches /3.8 inches /5.7 inches, used to connect the power cord (5 / sets).COM1 interface with the cable (RS-232C), used to connect directly to the CPU series PLC FX (not the same time using the programming controller)Disposable film (5 sheets / sets) for protecting screen against contamination of human computer interface.128MB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card.Expansion module for the GP3000 access to the CC-Link nnetwork and communication with the CC-Link master station (support for intelligent devices)COM1 pin adapter, which is used to connect the communication components that are dedicated to the COM2 interface to the COM1 interface of the man-machine interface CA3-USBCB-01 Manual CA3-USBCB-01 Manual. Adapter for EX module (5 / set)Connect to the SIEMENS PLC or MPI, used to connect the commercial type PROFIBUS connector COM2