CA1-WMALRG-01 User's Manual ()

Fitting on NETWORK FLEX interface. Connecting NETWORK FLEX communication cable. (5 / set)COM1 interface with the cable for direct connection to the CPU series PLC AUsed in a variety of host and man-machine interface for RS-422 connection13 pin input connectors for HTB and 16 pin output connectors. (1 / set)Expansion module for the GP3000 access to the DeviceNet network and communication with the DeviceNet master station12 CA1-WMALRG-01 User's Manual CA1-WMALRG-01 1 inch /10.4 inch (STN), thin film for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set).The main controller is connected to the man-machine interface for MPI communication2GB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card CA1-WMALRG-01 User's Manual. COM2 interface with the cable (RS-422), used to connect the 2-Port adapter to the man-machine interfaceSlave station module for connecting support for CANopenEngineering documents created by the LT interface to download images and logic programming software through the USB interface.Used to convert the USB interface to the serial interface (RS-232C) CA1-WMALRG-01 User's Manual. A modem or bar code reader that can be connected to support RS-232C.COM1 interface with the cable (RS-232C), used to connect directly to the Q series connection module (or other host)10.4 inch TFT models applicable parts, for the 10.4 inch man machine interface (TFT) into the 10.4 inch GP2500 (TFT) in the installation of the required accessories.COM 2 interface with the cable, for the conversion of the D-Sub 9 pin concave joint to the D-Sub 25 pin convex connector12.1 inches, replaced by a host of backligght (1) CA1-WMALRG-01 Manual. The main controller is connected to the man-machine interface for MPI communication5.7 inches thin film used for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set).Connect to the SIIEMENS PLC or MPI, used to connect the commercial type PROFIBUS connector COM2Used in a variety of host and man-machine interface for RS-232C connection