CA8-ODP10-01 User's Manual ()

Protection for GP rear connectors (large and small for each of the 1).The main controller is connected to the host computer interface (can be switched between RS-232C and RS-422) using the isolation module.USB cable clamp for preventing disconnection of connection (5 / set)2GB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card CA8-ODP10-01 User's Manual CA8-ODP10-01 15 inches, replaced by a host of backlight (1).The main controller is connected to the man-machine interface for MPI communicationGP-230/250/270 series is replaced by ST series, the gap filled with the opening of the panelFor 3.8 inch models, prevent cable loose from the USB cable fastening clip (5 / set) CA8-ODP10-01 User's Manual. For 3.8 inch models, connect the connector to the DIO interface. For connecting external I/O devices. (5 / set)Suitable for GLC2300 series10.4 inch TFT models applicable parts, for the 10.4 inch man machine interface (TFT) into the 10.4 inch GP2500 (TFT) in the installation of the required accessories.COM1 interface with the cable for direct connection to the CPU series PLC QUsed in a variety of host and man-machine interface for RS-232C connectionCOM2 adapter for converting the COM2 interface to the RS-422 terminal block128MB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card CA8-ODP10-01 User's Manual. COM1 pin adapter, which is used to connect the communication components that are dedicated to the COM2 interface to the COM1 interface of the man-machine interface.Expansion module for the GP3000 access to the DeviceNet network and communication with thee DeviceNet master station13 pin input connectors for HTB and 16 pin output connectors CA8-ODP10-01 Manual. (1 / set)USB cable to prevent disconnection of the fastening clip (5 / set)Fitting on NETWORK FLEX interface. Connecting NETWORK FLEX communiication cable CA8-ODP10-01 Manual. (5 / set)Used in a variety of host and man-machine interface for RS-422 connectionSlave station module for connecting support for CANopen