CA4-ATM10-01 User's Manual ()

COM2 adapter for converting the COM2 interface to the RS-422 terminal blockFor RGB input USB cable to prevent disconnection (2 / set)128MB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card.Suitable for GLC2300 seriesUsed in a variety of host and man-machine interface for RS-422 connectionGP-230/250/270 series is replaced by ST series, the gap filled with the opening of the panel10 CA4-ATM10-01 User's Manual CA4-ATM10-01 4 inch TFT models applicable parts, for the 10.4 inch man machine interface (TFT) into the 10.4 inch GP2500 (TFT) in the installation of the required accessories.Extension cable for connecting USB (Type-A) interface to front panel CA4-ATM10-01 User's Manual. Used to convert RGB to DVI-AUse external output for the GP3000 series of auxiliary connectors (5 / sets).Used to convert the USB interface to the serial interface (RS-232C). A modem or bar code reader that can be connected to support RS-232C.Extended cable for connecting USB (Type-A) (LT) interface.For 5.7 inch models, prevent cable loose from the USB cable fastening clip (5 / set).COM1 interface with the cable for direct connection to the CPU series PLC QMounting screws (4 sets) to be fitted to the hard panel at the interface of the machine CA4-ATM10-01 User's Manual. 13 pin input connectors for HTB and 16 pin output connectors. (1 / set)1GB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card.12.1 inch /10.4 inch (STN), thin film for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set).Expansion moduule for the GP3000 access to the DeviceNet network and communication with the DeviceNet master station5 CA4-ATM10-01 Manual. 7 inches thin film used for surface protection of man-machine interface from fingerprints, water droplets, dust and oil polluution (5 / set) CA4-ATM10-01 Manual. The main controller is connected to the host computer interface (can be switched between RS-232C and RS-422) using the isolation module.